Custom Gateway - Customer Support


Welcome to the Custom Gateway Support Portal

Here you can raise support tickets and read articles on common queries using the topic sections and search below

Image fit to image area

Follow

 

You can actually set your fit mode for your products to suit your image or print areas requirements. For example if your fit mode on your image areas are set to "actual", this apply the actual size of the logo/image into the image area when applied on the front end by the user, and the user could then adjust the size of the image to fit in the area as they want. But setting adjusting the settings to "largest side contain"  would make the logo to fit properly into the image area square of your garment as seen on the screen shot below.

 

 

 

 

 

 

 

 

 

 

 

Was this article helpful?
0 out of 0 found this helpful

Comments