Custom Gateway - Customer Support


Welcome to the Custom Gateway Support Portal

Here you can raise support tickets and read articles on common queries using the topic sections and search below

Text Areas | Auto Arc

Follow

Introduction

Auto arc is a text area feature that automatically bends text around the circumference of a circle.

Important Note: This is currently compatible with our Raster output (PNG, JPEG, PDF).

 

 

How It Works

The circumference of the circle is determined by the size and position of the text boundary in pixels (this must be square). The user's text will then be curved so that it follows the edges of the circle as closely as possible, based on the boundary specified.

 

Requirements

The text area must have:

  • Arc enabled
  • Multiline mode disabled
  • Text boundary enabled
  • Text boundary position and size set
  • Text boundary auto arc enabled

For best results, the (x, y) position of the text area should be the same as the centre of the text boundary.

 

 

Was this article helpful?
0 out of 0 found this helpful

Comments